Voice over Internet Protocol, also called VoIP, IP Telephony, Internet Telephony, Broadband telephony, Broadband Phone and Voice over Broadband  (continued)

Some broadband connections may have less than desirable quality. Where IP packets are lost or delayed at any point in the network between VoIP users, there will be a momentary drop-out of voice. This is more noticeable in highly congested networks and/or where there is long distances and/or interworking between end points. Technology has improved the reliability and voice quality over time and will continue to improve VoIP performance as time goes on.

It has been suggested to rely on the packetized nature of media in VOIP communications and transmit the stream of packets from the source phone to the destination phone simultaneously across different routes (multi-path routing). In such a way, the temporary failures have less impact on the communication quality. In capillary routing it has been suggested to use at the packet level Fountain codes or particularly raptor codes for transmitting extra redundant packets making the communication more reliable.

A number of protocols have been defined to support the reporting of QoS/QoE for VoIP calls. These include RTCP XR (RFC3611), SIP RTCP Summary Reports, H.460.9 Annex B (for H.323), H.248.30 and MGCP extensions. The RFC3611 VoIP Metrics block is generated by an IP phone or gateway during a live call and contains information on packet loss rate, packet discard rate (due to jitter), packet loss/discard burst metrics (burst length/density, gap length/density), network delay, end system delay, signal / noise / echo level, MOS scores and R factors and configuration information related to the jitter buffer.

RFC3611 VoIP metrics reports are exchanged between IP endpoints on an occasional basis during a call, and an end of call message sent via SIP RTCP Summary Report or one of the other signaling protocol extensions. RFC3611 VoIP metrics reports are intended to support real time feedback related to QoS problems, the exchange of information between the endpoints for improved call quality calculation and a variety of other applications.

The nature of IP makes it difficult to locate network users geographically. Emergency calls, therefore, cannot easily be routed to a nearby call center, and are impossible on some VoIP systems. Sometimes, VoIP systems may route emergency calls to a non-emergency phone line at the intended department. In the US, at least one major police department has strongly objected to this practice as potentially endangering the public.

Moreover, in the event that the caller is unable to give an address, emergency services may be unable to locate them in any other way. Following the lead of mobile phone operators, several VoIP carriers are already implementing a technical work-around. For instance, one large VoIP carrier requires the registration of the physical address where the VoIP line will be used. When you dial the emergency number for your country, they will route it to the appropriate local system. They also maintain their own emergency call center that will take non-routable emergency calls (made, for example, from a software based service that is not tied to any particular physical location) and then will manually route your call once learning your physical location.

The United States government had set a deadline, requiring VoIP carriers to implement E911; however, the deadline is being appealed by several of the leading VoIP companies.

This is a different situation with IPBX systems, where these corporate systems often have full E911 capabilities built into the system.

While the traditional Plain Old Telephone System (POTS) and mobile phone networks share a common global standard (E.164) which allocates and identifies any specific telephone line, there is no widely adopted similar standard for VoIP networks. Some allocate an E.164 number which can be used for VoIP as well as incoming/external calls. However, there are often different, incompatible schemes when calling between VoIP providers which use provider specific short codes.

With hardware VoIP solutions it is possible to connect the VoIP router into the existing central phone box in the house and have VoIP at every phone already connected. Software based VoIP services require the use of a computer, so they are limited to single point of calling, though handsets are now available, allowing them to be used without a PC. Some services provide the ability to connect WiFi SIP phones so that service can be extended throughout the premises, and off-site to any location with an open hotspot.

Telcos and consumers have invested billions of dollars in mobile phone equipment. In developed countries, mobile phones have achieved nearly complete market penetration, and many people are giving up landlines and using mobiles exclusively. Given this situation, it is not entirely clear whether there would be a significant higher demand for VoIP among consumers until either public or community wireless networks have similar geographical coverage to cellular networks (thereby enabling mobile VoIP phones, so called WiFi phones) or VoIP is implemented over legacy 3G networks. However, "dual mode" handsets, which allow for the seamless handover between a cellular network and a WiFi network, are expected to help VoIP become more popular.

The first mobile VoIP solutions were Fring and Truphone. Phones like the Nokia E60, E61 have been the first "dual mode" handsets capable of delivering mobile VoIP. With more and more mobile phones and handheld devices using VOIP, the nicknames of "MoIP" and MVoip (Mobile VoIP) have been attributed to these mobile applications.

Handheld Devices are another type of medium whereby you can use VoIP services. Since most of these devices are limited to using GSM/GPRS type of communication mediums, almost all of the handheld devices use WiFi of some sort.

Another addition to handheld devices are ruggedized barcode type devices that are used in warehouses and retail environments. These type of devices rely on "inside the 4 walls" type of VoIP services that do not connect to the outside world and are solely to be used from employee to employee communications.

The majority of consumer VoIP solutions do not support encryption yet. As a result, it is relatively easy to eavesdrop on VoIP calls and even change their content. There are several open source solutions that facilitate sniffing of VoIP conversations. A modicum of security is afforded due to patented audio codecs that are not easily available for open source applications, however such security through obscurity has not proven effective in the long run in other fields. Some vendors also use compression to make eavesdropping more difficult. However, real security requires encryption and cryptographic authentication which are not widely available at a consumer level. The existing secure standard SRTP and the new ZRTP protocol is available on Analog Telephone Adapters (ATAs) as well as various softphones. It is possible to use IPsec to secure P2P VoIP by using opportunistic encryption. A notable softphone which does not use SRTP but uses strong encryption by default is Skype.

The Voice VPN solution provides secure voice for enterprise VoIP networks by applying IPSec encryption to the digitized voice stream.

VoIP has become an important technology for phone services to travelers, migrant workers and ex-pats, who either, due to not having a fixed or mobile phone or high overseas roaming charges, choose instead to use VoIP services to make their phone calls. Pre-paid phone cards can be used either from a normal phone or from Internet cafes that have phone services. Developing countries and areas with high tourist or immigrant communities generally have a higher uptake.

Caller ID support among VoIP providers varies, although the majority of VoIP providers now offer full Caller ID with name on outgoing calls. When calling a traditional PSTN number from some VoIP providers, Caller ID is not supported.

In a few cases, VoIP providers may allow a caller to spoof the Caller ID information, making it appear as though they are calling from a different number. Business grade VoIP equipment and software often makes it easy to modify caller ID information. Although this can provide many businesses great flexibility, it is also open to abuse.

On our A dedicated hosting service, dedicated server, or managed hosting service is a type of Internet hosting where the client leases an entire server not shared with anyone. This is more flexible than shared hosting, as organizations have full control over the server(s), including choice of operating system, hardware, etc. Server administration can usually be provided by the hosting company as an add-on service. In some cases a dedicated server can offer less overhead and a larger return on investment. Dedicated servers are most often housed in data centers, similar to colocation facilities, providing redundant power sources and HVAC systems. In contrast to colocation, the server hardware is owned by the provider and in some cases they will provide support for your operating system or applications.

<<PREVIOUS PAGE     |     HOME PAGE OF VOIP INFORMATION>>